Discussion Locked

Micropolis SCSI drive problems

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have obtained two Micropolis 3391WD SCSI drives, which regardless of how I configure the ID's (using the jumpers) cannot detect using an Adaptec AIC7895 controller (on the MSI motherboard). The controller works fine with other SCSI drives that I have (IBM 18Gb).

Anybody out there with any experience of these drives?

5 replies

by eldiva59

OK Stephen, point taken, I concede defeat. I have since discovered that the drives are SCSI 3. Apologies for previous reply.

However this begs the question(s), hy won't the drives work with an Adaptec 19160N adaptor? As far as I can see fromAdaptec's site, this adaptor can handle SCSI 3 devices, or am I still going wide of the mark? Is it that they need terminating (Passive or Active, LVD or other)?

Any further comments gratefully accepted!

This discussion is closed to new replies.