Discussion Locked

Microsoft Wireless optical mouse

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Wireless optical mouse blue does not respond after installing

5 replies

by qballrail

Based on the limited information, I can only recommend some "generic" suggestions. First, try removing and reinstalling the software. Also, depending on the OS you are running, it might install default drivers and run fine. Perhaps removing the device, in the Device Manager, then shutting down and removing the IR sensor. Reboot fully then shut down again. Reinstiall the sensor and boot again, Windows SHOULD auto-detect. If it does and offers to install generic drivers, then run with that and see what happens. If not, and it requires the facory drivers, reinstall them when prompted. Follow the wizards to completion. Then go to the Website and find more current drivers.

However, it is possible that if you are running a pre 98SE OS, you may not be able to run this mouse.

Try this but if it doesn't work, providing a little more information would better enable us to assist you.

Good Luck! :)

by akula

Make sure you have "synced" them on the proper RF channel. I had this problem with my Memorex wireless. Check your instructions- you may have to press a button on the transceiver and then on the mouse to get them talking to one another.

This discussion is closed to new replies.