Discussion Locked
0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My 3750i scanner (less than 1 yr old) has just stopped working. The lamp lights up but when I try to scan something it makes a funny noise (similar to what it would sound like if the lamp was in the locked position, but it is NOT)and the lampwillnotmove. I've turned it off/on, unplugged it and reinstalled the software. I have also contacted Microtek tech support twice but with no response.
5 replies
Hi as it is, it sounds as if the transport mechanism has jammed ie the same as locked. You have 2 choices either open it up (assuming not under warranty) and check mechanism or to buy new. These days a Scanner is so low in price is it worth your time ?.
Rich
by mellb61508
Poster rated this answer
by thechas
If this is a parallel port scanner, make sure that your printer is turned on.
I have had similar experiances with some scanner / printer combinations.
Chas
by mellb61508
Thanks. I did get it to working again. I think the plug for the little motor that drives the belt was not seated fully. I did open it up since it was out of warrantyand did get it to working again. I was just irritated b/c I haven't had it that long and I rarely used it. Thanks for your help.
by mellb61508
This question was closed by the author
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies