Discussion Locked

Mirrored drives

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Is it possible thru software or hardware to mirror drives on an NT workstation? In certain situations I have individuals who prefer not to backup critical and sensitive data to a server ( or any where else for that matter ), leaving them extremely vunerable in the event of a disk crash.

7 replies

by ebob

According to Technet, disk mirroring is only available with NT Server (same with W2K!).

It is possible in H/W.

The simplest way is to get a PCI RAID controller that supports RAID Level 1 (which is mirroring). Set it up (and add the 2nd HDD), and away you go. The toughest part of this is finding such a card. Try www.promise.com as a first look.

You could conceivably also swap out the mother board for one that supports IDE RAID, or even SCSI RAID and give these morons, er, nice friendly users, SCSI HDDS. But that sounds like a lot more work than they're worth.

The simplest thing is to dust off the company's policies, have them pretend to read and sign-off. Then let them fly in the wind themselves. But perhaps that's not an option, as tempting as it may be.

by jereg

The first answer is correct in responce to your question, the problem you have is actually disaster recovery. These paranoid users can cost companies tons of money. I've dealt with people like this in the past, and there seems to be one at every firm. Critical data MUST be backed up and copies stored offsite. That'a the bottom line. After 9-11-01, we've seen the worst that can happen. Make management aware of this. If the data is important,and they don't want it backed up on the server, install a tape backup on their PC and show them how to use it. then, it's their responsibility if anything happens.
Also, most backup s/w for networks can backup PC's as well.
Good Luck.

This discussion is closed to new replies.