Discussion Locked

Mixing ram on a PC100 motherboard

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I recently installed 64 megs of ram on a PC100 motherboard. The original ram is SDRAM in an eight chip configuration. The new ram is in a four chip configuration and when the machine boots it is telling me that it is NVRAM, it used to say SDRAM in DIMM slot 1 now it says NVRAM DIMM slot 1,2. The new ram is 133 mhz whereas the old is 100 mhz. The machine seems to be working fine. What is this strange Message ? ( NVRAM )

7 replies

by churdoo

If I recall correctly, the NV means non-volatile; someone please correct me if not so. I doubt that the PC133 is truly non-volatile, but since PC133 was not out when your PC100 motherboard was developed, it simply does not have an appropriate message programmed for the PC133 DIMM.
I just want to point out the obvious and say, "If it's not broke, don't fix it." but seriously, I do have one caution for you, cuz I'm not sure by your description if you left it this way ... just make sure that you put the slower PC100 DIMM in the first slot and the PC133 in the next slot. A lot of BIOS will just query the first slot to determine things like timing so by putting the slower one first, you can avoid potential timing issues.
--Charlie

by csmith

DIMMs come without EPROM and With EPROM.
That is the NV message.
The old SDRAM was without. That was common.
Most of the new SDRAM is with.
Ans.#1 has a point. The old ram should be in Bank 0.
It appears that it is not critical in your case.
Regards, Chris

by dmiles

The bios is reading the new ram as Non-Volitale Random Access Memory,type of memory that retains its contents when power is turned off.
NVRAM is a combnation of SRAM and EEPROM chips.
The message is not strange it is reading the PC133 as the faster ram over the PC100 as the dictated by the slots.

This discussion is closed to new replies.