Discussion Locked

Mobo Upgrade Problem

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Trying to upgrade Gateway 6/400 with new Intel D815EEA mobo and P-III/900 processor, system will not boot. Mobo POSTs okay (1 beep, four green diagnostic lights on back), but system hangs after starting to boot.
Someone suggested I would have to replace the OS (currently Win 98se); is this agreed?
Any other suggestions?
Thanks!

9 replies

by csmith

Win98 SE is probably the best OS for this setup.
Disconnect the HD, clear the HD settings from the BIOS, and try to boot on a Win98 floppy.
That will verify that the new BIOS and new MB are OK, if the PC boots to the floppy.
(Remember to change the boot order to A:,C:)
Reconnect the HD, write the HD BIOS setting, boot on the floppy, and try a setup.exe from the Win98 CD.
(The HD disconnect is to bypass some buggy BIOS problems with the boot order.)
Regards, Chris

by rrenn46

The system should still boot .The os is fineI am running a pIII 933 with win98 asus mobo.
First I would clear cmos.Even though its new sometimes this helps because they(mobo) are tested.Have you set up your cmos? Is your video card agp or pci?thats the next thing that will lock it up.Its hard to pin point a problem without knowing all the hardeware you have on the mobo.If you want email me this is what i do i build them from scratch.

by dmiles

Check the video card to see if it is seated properly,it will cause the system to hang upon startup,check Microsoft knowledgebase for Ref to problems listed with Win98SE
Then check your memory to make sure that it is installed properly.
Last resortto reinstall the OS.

by muddyknees

I dont think its the OS. Try reinstalling the OS. If it hangs again then most probably its a hardware problem.
I had the same problem before that recurred till my mobo went completely dead. A memory module was also broken. It was something like SUWIN.
I can say its only one of three things:
memory, mobo, or video card. But its most probably the first two. Video usually causes random lock-ups.
Try a diferent memory module and check mobo settings.

This discussion is closed to new replies.