Discussion Locked

modem

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
how does the modem work?

5 replies

by thechas

Modem stands for Modulator - Demodulator.

At it's most basic, the modem converts a data stream into a series of signals (audio for a dial-up modem), and converts a series of signals back into a data stream.

There is a specific structure, or protocol to the data stream.

There are specific requirements on the signal structure, amplitude, and connection.

If you want to go into further detail, you can download data sheets and design guidelins from most of the modem chipset manufactures.(Intel, Agere, PCTell, Conexant)

by mdelyea

Modem is short for MODulator/DEModulator. It works by taking digital data and transforming it into an analog (sound) signal suitable for transmission over a telephone line. The modem on the sending end modulates to analog and the modem on the recieving end demodulates the anaolog signal back to digital data. There are currently 3 standards for modems to communicate with, Flex (almost gone now), V.90 (most widely used) and V.92 (the newest standard). They basically relate to compression, error correction and "handshaking" (when two modems first connect they must decide on the speed they can best communicate at and the error correction protocol they will use). A 56k modem uses data compression to reach a data tranfer rate of 56000 bits per second. This is never the case however, with speeds above 50k being impossible. More likely you will connect at 43k to 49k.

This discussion is closed to new replies.