Discussion Locked

Modem clicking and no dail tone

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Trying to install internal modem 56k on win2k machine,
hardware and software install fine but when trying to connect i get a clicking from the modem and no dail tone message.
I have checked all settings - irq, com, tone/pulse dail, etc. and have checked phone line
this is a home phone line so am not connected to pbx exchange and it is a analogue line.
please help.

4 replies

by otl

Is it Plugged into the line jack not the phone jack on the modem ?

Sounds like it is not at this time. Looking for dialtone and finding the telephone.

by paulkinsey

one of the first things I checked, no dailtone on phone when phone is pluged in to phone jack either.
thanks anyway.

by thechas

You say there is no dial tone from a phone plugged into the phone jack on the modem.

That leaves a few options:

Bad phone cable.

Bad modem. (open circuit for phone line)

Mis-wired wall jack.
Sometimes a 6 pin jack is used for single line service. If the wires are not connected properly, a 4 wire cable will not have the signals on the correct pins.

Chas

This discussion is closed to new replies.