Discussion Locked

modem conflict?

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a duron 1300 with a ga-7zxe motherboard with 256mb ram running win98. I recently upgraded to ati 64mb apg card. But when I installed my modem and connect to the internet everything just takes a turn for the worse. First I get a couple differnt fatal execption errors, then after reboot it wants to preform scan disk and start in safemode. In device manager there are no conflicts and everything shows to be running ok. I have the most updated drivers for everything. This behavior only occursafter the moden is installed and connected for the first time, without the modem everything works ace. I look forward to your suggestions. Thanks.

6 replies

by thechas

Since you did not specify the specific modem, I can only provide a generic answer.

My best advice, is to try a modem with a different manufactures chip-set on it.

I have had several motherboards that just would not function properly with certain modem chip-sets.
I have had the problem with several different modems on several different motherboards.

The 'best' option may be to use an external modem.
If you live in an area that has thunderstorms, an advantage of an external modem, is that if lightning hits the phone line, it is not apt to take out more than the modem. With internal modems, a lightning strike to the phone line can take out the whole PC.

Chas

by djent

I assume you are using a modem without jumpers for config. Your video card may be using 6E8 which cascades to 2E8, this conflicts with COM4, a common choice for auto detect. get a modem with hardware config jumpers or an external serial modem.

This discussion is closed to new replies.