Discussion Locked

modem connection speed

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I recently submitted this question but could not find it posted.
I have a new PC with Windows XP and a .V90 PCTel Platinum modem. I have to set my max connection speed at 9600 bps or I will not be able to connect. My IPS's computers' protocol errors and timeouts prevent connecting. My ISP is not willing to help as they are not up to date on WinXP. I've tried adding strings from the modem website, changing all the parameters possible, but to no avail. Compaq had me connect to an 800 number ISP with no problem. I know that this modem is software driven and has been known to cause this type of problem. Is there anything I can do to try to connect at a higher or max speed. Thanks.

5 replies

by true_texan

It may be that your ISP is the problem. When you dial in, the answering modem usually starts the signal "negotiation" at its max speed. The modems then step down until they can agree on a stable transfer rate. If the ISP is designed for 56K dialup access, this may be your problem as some 56K modems will not step down below 19.2.

What I'm reporting here is what I've been told more than what I know for fact. But I do know that the company I work for maintains two independent RAS servers for this very reason. One RAS server is configured with 56K modems. The other RAS server has only 19.2K modems.

To quickly test this theory, step up your max connection speed and test the connection. If you start getting connections at 19.2, thisvery well may be the problem.

Hope this helps!

by gamco

Thanks for your response True Texan but my modem doesn't step down in speed. It just doesn't connect. In fact, once in a blue moon it will connect at a higher speed than selected (except when 9600 or lower is selected) but will not download any web pages or connect to my email. It even connected at 115,200 , which I know isn't true, but that's what it says when connected. I'm not sure what's happening, but I still need help. Thanks. Glenn

by otl

Under modem properties advanced settings is the 16550 UART checked and buffers set to maximum? Or have you tried disabling 16550 UART?

Does your ISP support .V90 Protocol?

by gamco

I've tried both with and without the UART checked, but to no avail. My ISP does support .V90
It only connects to long distance ISPs.

by lump_16

I work for an ISP and while I'm not up to date on XP I'm at lest willing to give it a shot.

Is this an entirely new computer with XP on it or was this a computer that may had been upgraded to XP. Or was your modem taken from an existing (non-XP) computer and put into the XP system.

Make sure the drivers are XP drivers.

Check out http://www.modemsite.com they have a plethora of info about dial-up modem issues.

Hope this helps some,
Brian Wright
http://www.wright-onthe-web.com

This discussion is closed to new replies.