Discussion Locked

Modem not detected in win95

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Installing an external u.s.robotics 33.6 faxmodem to replace an internal 28.8 (compaq). Compaq - Win 95 machine. "No detection
From device mgr - I removed com 1, from the control panel I removed the old modem, shut down, then physically removed the old modem. Hooked the new modem up & Win 95 did not find it.
I installed it from the Add Hardware control panel, and the correct driver from the internet. The modem is using com 1, com 1 is using IRQ 4.
When attempting to dial out or do a diagnostic test windows can't detect the modem. Several of the 7 lights on the modem flash on / off during this process, so it is doing something. This modem has 8 dip switches - no clue which ones should be on.
I also put a .inf file in the inf folder - this was with the driver. Tried other windows drivers also. I have no manual for this modem.

5 replies

by dmiles

One you mentioned you removed COM 1,did you re-enable Com 1? Enable before you installed the new modem.
The BIOS is trying to install on a open COM Port.
If you want to install on COM4,open the Device manager and the locate the modem line then click on the plus beside mode,highlight the modem listed and click the properties button,select the resources tab and choose to manually set resource to specify COM Port 4.
The other option is to enable COM Port 1 in CMOS Control panel and then reinstall modem on com1.

This discussion is closed to new replies.