3. conflict between the modem and another hardware Port, IRQ or memory addresses.
To change the resurces such as the COM com port
My Computer-> properties -(TAB TO) device manager-> (click) the "+" near the modem-> select the modem - >properties->(TAB) to Modem - in port choose a port from the availble ones. exit answer yes to the message says "reboot".
4.Installation.
This could be software or hardware installation problem.
For software, reinstall the software and preferable that it is the lates from vendor site and is the right one for the OS.
For hardware, afirm setting the modem in the slot or change the modem to another PCI slot if the slots is bad. or if it is external modem make sure the cable connected to the PC serial orUSB is connected firmly and the correct external port..
5. Type of modem.
Winmodem will not work in DOS or a low CPU horse power, since it is depending in a driver wich use windows multi processing and CPU.
6. Problem in software setting.
Check the proper selection of the country and it is supported in the driver you installed.
start-> setting -> control panael->->Telephony.
Check the modem setting such as wait for dial tone before dialing.
start-> setting -> control panael-> modem ->select the modem-> Properties -> (TAB) Connection -> check the box
7.Voice mail on the phone line.
Check the phone for a broken dial tone or beeps which indacte a voice mail message is waiting.
Check your voice mail.
Uncheck "wait for dial tone before dialing"
start-> setting - control panael-> modem ->select the modem-> Properties -> (TAB) Connection -> uncheck the box
8. Device driver.
Make sure that the driver is the latest and the right one for your operating system.
9.surge protector.
Make sure that the line has to go from the wall to the surge protector, then from the surge protector to the modem.
10. Envirnment.
Check for interferance of