Discussion Locked

Modem Problem

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am installing a new modem " Hi-VAL 56K" Modem. It's a data/fax modem for windows98. The problem is i used every port available to try to get this thing to work - it simply want work. For com1 i'm getting a error "Couldn't open port" and this is the same for all the port i am using. I updated the driver, but windows98 telling me I'm already using the best driver. The modem is secure inside, the phone line is attached okay. Do anybody have any ideas on what i can do to get thing to work? I noticed also that this is not a popular modem...but it's new. Thanks for your help!!!!

11 replies

by nap jones

The first thing to do is go into Device Manager and remove the modem and all of the comm ports. Then reboot your computer, and go into CMOS settings and disable all the comm ports except for comm 1. Save the CMOS and the operating system should reload the modem and assign it to comm 2.

by winninghamusn

have you checked the resorces under the device mamager is it using other irqs or other address if so try and see if you can use another address or irq. you should be able to change one of those, or even tring to change the config. from the org. to another config.setting

by bsg208

Go to control panel,then to modem.Highlight your modem and delete it from system.Reboot computer. When it comes back up it should find your modem and start trying to install it,click on( have disk) button.Put your cd in your drive and it should findthe proper driver,and install modem.It will probally be located in comm 5.

by thechas

1. Go to either hi-vals, or the chipset mfg website and download the latest drivers for the modem and your OS. The drivers on the CD are often 3 revisions old.

2. From device manager, and add/remove programs, un-install / remove the modem.

3. Shut down and remove the modem card from the PC.

4. Re-boot, and install the driver.

5. Shut down and place the modem back into your system.

6. Boot up and follow the device wizard prompts.
You may need to reboot again before the modem will work.

I was getting this same error continuously with PC-Tel Chipset modems on several Super 7 MBs. Changing to a Lucent chipset modem solved the problem.

If the modem still does not work, it may be bad. The Couldn't open port error is common for a "zapped" modem.

by mdelyea

How old is your computer? Is the chipset on the modem ESS? If so, you will get that error if you have an older non-MMX cpu. If this is the case there is no fix and you should get a hardware modem instead.

This discussion is closed to new replies.