Discussion Locked

modem won't connect

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I wish there were a "modem" category.

I am trying to test an RAS setup by connecting two modems using a standard 6 ft. phone cable. Since I have no dial tone, I've been trying to force a connection using AT commands in HyperTerminal. My problemis the USRobotics Sportster 33.6 external faxmodem that is connected to the server. I can establish communications to it from the server with HyperTerminal, but it refuses to dial. Here are some of the commands that I've tried, and the results.Command Response Notes
ATD NO CARRIER response is immediate
ATA NO CARRIER response is immediate
ATX1D NO CARRIER response is immediate
ATH0 OK puts modem on hook
ATH1 ERROR but puts modem off hook
ATO0 ERROR response is immediate

All the other AT commands seem to work OK.

10 replies

by mpdcsup

It's true, the telco has to get involved, but it has nothing to do with dialtone -- it has to do with power for the circuit. Get a RJ-11 splitter and hang each modem off the splitter as though they were telephones (in the wall jack) or plug each modem into a different *live* telephone jack.

You should be able to perform your tests just fine. Keep in mind, after awhile the dialtone will go away (like you left the phone off-the-hook), long enough and the siren (to remind you to hank up) willsound, but this should not interfere with your testing -- just your ears (turn down the volume.)

by pvp

OK. You need the phone company or something similar to provide power and carrier, and probably dial-tone (I doubt the modem will be faked into dialing without it).

Radio Shack used to have a phone testing box. I don't know if they still do--this was 10 or 20 years ago, and it was about $800.

You can't use a splitter and expect to talk. Yeah, you'll get power, carrier and dial-tone, but what are you going to dial? Your own number--busy outgoing, so the answering modem won't get anything.

If you don't have two phone lines in the house, see if you can get a neighbor to help. Either lug a machine next door, or get 100' of phone line, put RJ-11's on both ends, and run it between houses.

The serial-null modem-serial isn't the answer, either. Win thinks that's direct-connect, which is a whole 'nuther interface.

by wgirid

Hi!
Most modems cannot connect without a line voltage (supplied by the exchange circuitry). If a suitable DC voltage is present a connection can be made if one modem is given command ATD and the other ATA. No dialling has to take place, only the handshake procedure (modem to modem), which is initiated by these commands. This setup will not test a modem's ability to answer incoming calls, however, as there will be no "ring" signals.
Regards
/WGIRID

by driordan

I have posted this question here and on experts-exchange, and I have gotten a dizzying array of answers, from "just issue an ATD command" to "if you connect two modems directly, the voltages used to transmit will damage the receiving circuits ofthe other modem." None of the answers have been satisfactory.

So here's the situation: if I give my laptop's (internal Actiontec v.90) modem an ATA command, it goes off hook and starts whining and farting, trying to make a connection. If I issue the same command to the server's (external USR Sportster 33.6) modem, it comes right back with NO CARRIER.

Why the difference?

This discussion is closed to new replies.