Modems
My modem wont dial out it says port alredy open.
How do I close the port so it will connect and dial?
Hardware
My modem wont dial out it says port alredy open.
How do I close the port so it will connect and dial?
by dancoons
by cbach1997
Did it work before, or is this a new setup?
If you are using an internal modem, and don't have things hooked up to your serial ports (i.e. mouse, etc), I would go into your BIOS and disable any on-board ports temporarily.
Next, I would look for ANY running software and close it - some programs (especially fax software) can hog ports leaving them unavailable for anything else.
Finally, see if you can reassign the device's resources used in the control panel device manager.
Good luck,hope this helps,
cbach1997@hotmail.com (not user deleted)
by dancoons
by thechas
You either have a driver problem, or a dead modem.
From control panel / modems,
select your modem, and select remove.
Re-boot, and allow Windows to re-install the modem driver.
Re-open control panel / modems
Click on the diagnostics tab.Select your modem, and click on more information.
If the modem passes the tests, the bus side hardware and driver are functioning properly.
If not, you may be able to correct the problem with updated drivers for both your motherboard, and yourmodem.
There are different driver installation procedures for different modems.
For some modems, you need to boot the system with the modem removed from the PC, install the driver, then shut down, and install the modem.
If you had a lightningstorm recently, it could be that the modem was damaged by the lightning.
Chas
by dancoons
by dancoons
This discussion is closed to new replies.
Sort by Trending