Discussion Locked
0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a Sampo Alphascan 411 that's 4 yrs old. Recently, I've been experiencing problems with it. The display just blacks-out all of a sudden. Sometimes I could use it for a few hours with no problems, other times it would just black-out after a few minutes of use. What could be the problem? Is there something I could do or do I have to have it fixed in the shop?
7 replies
by dmiles
One check the video card to see if this is the problem,install another video card,if you fell that the mnitor is the problem then have a technician look at it or consider replacing the monitor.
Caution when opening monitors,you have a large capacitor on the inside that holds a charge
by panget
Poster rated this answer
by donmars
Does the light on the front flash amber or green or flash at all. Which O/S are you using, is this a newer or older computer? It could be the Video board but before you check turn off the monitor for about 15 to 30 minutes (you can try 5 minutes even 2 minutes longer is more foolproof), leave comp on and booted. Turn monitor back on, anything? Jiggle cable in back at the monitor and/or computer connection when it goes black. Can you try another monitor when this happens? Just unplug the monitorwithout shutting down comp and connect, plug in and turn on substitute monitor does that work? If not then problem is Video board. Try reseating video card. Also when monitor goes black do not turn off, leave on for 30 minutes then check the temp on top toward back. Is it cold or still warm. If cold then monitor is defective, if warm it could still be monitor but more likely Video board.
by panget
Poster rated this answer
It sounds like the problem could be heat related. Check your case for "environmental hazards" ie. dust. Clear out the crud verify that the video adapter is properly seated and the cooling fan is un obstructed. Also check power cord for damage. Jiggle the video cable to see if you can reproduce the "black-out". If none of this helps, then you may want to investigate a new video adapter. Good luck - Steve
by panget
Poster rated this answer
by panget
This question was closed by the author
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies