Discussion Locked

Monitor Color

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My computers monitor does not show the color red or green, I am getting only blue and white on the color palette. I have also installed a new VGA 3D card which is working well but still no colors.

Any info regarding monitor repairs would be appreciated.

7 replies

by phil.kesteven

Sounds like one of the colour 'guns' have gone in your monitor. So instead of having the full spectrum of red green and blue, maybe the red one has gone which makes everything look blue (and maybe slightly dim/frosted). Try the monitor on another PC, just to make sure, but if its a new monitor, it will be covered on its warrenty.

by macchia

It turns that it seems the power suppy is at fault though the MB.
Since upgrading the moemory however the color came back on its own accord, I suspect it could also be the plug from the power supply on the MB.
Thanks for all the info which I did try out.

by grbeckmeyer

I would say that about 75% of the times I see this it is due to a bent pin on the monitor cable. Take a close look at the connector, if any of the pins are flattened down, you should be able to pull them back out using a needle-nose and get it working again.

by macchia

It turns that it seems the power suppy is at fault though the MB.
Since upgrading the moemory however the color came back on its own accord, I suspect it could also be the plug from the power supply on the MB.
Thanks for all the info whichI did try out.

by mskiproductions

I agree with Answer #2. Most of the monitor problems i find are to be faulty cables. As the is the cheapest option anyway, it would do you no harm to buy a new cable. If you dont find any bent pins, it may be a loose connection within the cable itself.

Matthew Shine.

Computacenter, Europe.

by macchia

It turns that it seems the power suppy is at fault though the MB.
Since upgrading the moemory however the color came back on its own accord, I suspect it could also be the plug from the power supply on the MB.
Thanks for all the info whichI did try out.

This discussion is closed to new replies.