Discussion Locked

Monitor goes off every now and then.

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My monitor goes off while working with my
PC and when I put it on again I continue as if nothing had happened only to switch it itself off again after sometime.I have tried changing the monitor but the second monitor also behaves the same.Please help out.

10 replies

by quahsays

could it be the power saving settings?
there's a setting that could turn off the monitor after a specific time, only when activities is detected would the system bring the monitor back to life.

by ann777

If this is an older system with a monitor that is a few years old, then i suggest that you replace the video card. I've seen this happen when the video cards start reacting to heat and just quit when they get too hot. If the video is embedded into the motherboard, then disable it and add a separate video controller.

by kep 001

You indicate that your monitor goes "off". Does the screen just go dark or does the power indicator lamp go off?

If the screen goes blank it is your screen saver routine where the screen saver has been set to "none". To get it to power up youshould be able to press a key or twidle your mouse. It may take 3-10 seconds for the monitor to display again.

A quick check would be to right click the desktop, select properties and then screensaver. If "none" is selected you could change it to one of the options and then that would display instead of a blank screen. Or you could disable it all together.

If this isn't it you can check your power management settings in your BIOS.

Either way, this should not have just started on itsown accord. If the unit was working correctly someone would have to have changed one of these settings to have started this behavior.

Kep

by kep 001

You indicate that your monitor goes "off". Does the screen just go dark or does the power indicator lamp go off?

If the screen goes blank it is your screen saver routine where the screen saver has been set to "none". To get it to power up youshould be able to press a key or twidle your mouse. It may take 3-10 seconds for the monitor to display again.

A quick check would be to right click the desktop, select properties and then screensaver. If "none" is selected you could change it to one of the options and then that would display instead of a blank screen. Or you could disable it all together.

If this isn't it you can check your power management settings in your BIOS.

Either way, this should not have just started on itsown accord. If the unit was working correctly someone would have to have changed one of these settings to have started this behavior.

Kep

by p.i.b

Do you know the type of video card you have, AGP PCI or ISA. If one of the former, its worth checking that the video card is seated correctly, particularly if the machine has been moved. If you've tried a different monitor have you changed the power cord, just in case its faulty? If its plugged into the base station try plugging it straight into a power socket it may be the pwoer supply has a fault on the through socket.

This discussion is closed to new replies.