Discussion Locked

Monitor making a High-Pitch Noise

0 helpful
23 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

19" ViewSonic GS790 Monitor makes high-pitch noise, especially immediately after starting up or changing resolutions.

Changing refresh rates/resolution does not fix the problem (tried at all refresh rates/resolutions to no avail)

What does work is Tilting the monitor up or down. Doing this immediately stops the sounds for the time being.

Does not always happen, and sometimes the sound is louder and more prevalent then others.

I have noticed that after the computer boots up, if it is making the noise, that changing the color of the background to different colors effects how loud the sound is, to a point -- this doesn't fix the problem, only lowers/raises the sound.

I've opened the monitor case to try and locate the sound. It seems to emanate from a black case in the back left corner of the monitor (facing the monitor). This box is the same box you adjust to change focus/brightness. I changed both the focus and the brightness, seemed to have no effect on the sound. After trial and error I got the monitor back to normal focus/brightness...

Looking for a way to fix the problem so that it doesn't come back, without having to buy a new monitor or get a refurbished one from ViewSonic.

Thank you very much for your time.

23 replies

by still_learning

Unless you are qualified to do monitor repairs, I would not venture inside a monitor case. You stand a good chance of a high voltage static shock. As for the high pitch whine, this usually indicates a monitor that is on its way to equipment failure,I believe that a new or refurbished monitor is your best option unless by chance, your monitor is still under warranty. Hope this helps.

by aceviper

It is still under warrenty, it is a year old. However the only options I have with it are to send it in for repair (and be without a monitor for however long that takes), or end up with a refurbished replacement (which I really don't want)...

Hoping there is some settings fix, but I'm willing to attempt monitor repairs with instructions.

Thanks for your reply.

by maxwell edison

I found a couple of possible causes for this.

Magnetic field interference stimulates the oscillation to cause the high pitch noise; it will not affect the performance of the monitor.

There are 2 way to minimize/eliminate to noise:

- change the refresh rate.

- tilt up/down the monitor physically.

Your GS790 monitor is reported to have up to 95-Hz refresh rate at 1280 by 1024 resolution. However, I've also seen a reported Refresh Rate of 76 at maximum resolution. Both reports came from PCWorld.com - go figure. Nonetheless, try to change it (to something less than the maximum.)

http://pcworld.pricegrabber.com/search_prodsummary.php/masterid=150594/ut=0cfd88a387c574c4

http://cssvc.pcworld.compuserve.com/computing/cis/article/0,aid,100431,00.asp

REMOVE SPACES from the pasted URLs

----------

This noise is probably more noticable the brighter the screen is or when a large amount of white is being displayed. Monitors draw more power when the screen is brighter. Two things you can try:

1. lower the brightness setting on the monitor

2. Use a darker color sceme like High Contrast Black.

by aceviper

I tried refresh rates of 70, 85, and 100 and all produced the problem.

I had tried using darker color scemes and lowering contrast rate-- it does seem to reduce the sound volume a bit, but it is still there :(

And the reason it said 95 at 1280x1024 and 76 at max resolution is b/c 1280x1024 isn't the max resolution.

Thanks for the reply.

by thechas

What you likely have is loose windings on the flyback transformer (or some other parts in the horizontal circuit).

While annoying, it should be nothing to worry about.

However, if the monitor is bumped or transported, you do have an increased risk of failure from the part breaking.

A knowledgeable monitor technician should be able to repair this with either replacing the part, or securing the part with high voltage rated adhesive.
CAUTION: The parts that are most likely loose have around 40,000 Volts on them.
Any serviceing needs to be done by a trained qualified technician.

Chas

by ann777

If you have already dusted and blown out all the components, then you need to come to the realization that you may not be able to "fix" the problem... and that it will slowly get worse with age.

What's worse, if you do find a "fix", you will only delay the inevitable ... which is to get it repaired or replaced. And you may not be under the warranty period when it does this the second time around.

There are probably capacitors that are slightly swollen on top... these tend to turn brown or sometimes look like they are leaking. Monitors do not repair themselves and they only get worse with time. All the electricity draws dust and the boards and electrical components cook themselves.

Get it repaired with ViewSonic (while you still can)... even if it means that they send you a refurbished one (which is most companies' practice -- after all they are going to do the same with yours -- fix it and send it to another customer with the same model under warranty). Your monitor is no longer new.

by rapidad

Viper, we cannot emphasize too strongly:

STAY OUT OF THE MONITOR,

try the tricks suggesed above from outside the case. good luck.

by lee.paxton

I couldn't agree more, don't open up the monitor unless you are trained as an electronics engineer. Monitors have a very high amount of residual static electricity around the rear of the screen, and it has been known to stay there for days before discharging properly. One touch on that or some of the components on the board, and you'll end up being thrown against the wall and possibly burned hands. (the voice of experience)

Check to see that there isnt any electrical equipment around or near the monitor, as electromagnetic interference can and does cause problems with monitors, be it sound comming from them or a touch of screen wobble. If this isn't the case, I would advise calling your supplier or the one in charge of you warranty and getting a replacement.

Nine times out of ten its speakers possitioned too close to the screen, or an array of power sockets behind it.

Hope this helps.

by nmlhaus

Absolutely agree with THECHAS. This is very very common on all TV's and also large screen monitors. The IHVT (integrated high-voltage transformer) has windings that are laminated in place under the black surface skin. Through age, heat, vibration etc, the laminations deteriorate. What you get are 15KH noises that a lot of people, especially old-farts like me, can't even hear. The reason you hear it coming and going is that different brightnesses require different current through the transformer, and cause the laminates to start singing. Also, agree with everyone else who has tried to warn you. These are lethal voltages, and you don't sound like you have the healthy respect for electricity that keeps us old ET's alive. You need a new IHVT, if you want to keep this monitor, request that the warranty be satisfied by repairing your monitor, even if it means a longer turn around. Good luck!

by aceviper

After all the replies, I see this isn't something I'm going to be able to fix myself like I hoped. Since many of you gave the similiar answers, going to split the points between you. Thank you all for your time and replies.

by aceviper

Going to leave the question open for a few more days, if I don't get anything new I'll close it and split the points.

Also if someone reads this after it is closed and knows something that will work, please email me at:
aceviper@hotmail.com subject "EQ" (this will make sure it passes my spam filters)

by bob f

what that is the actual sound of the flyback transformer ,which generates the hi voltage for the monitor and it operates at the hi end of the human hearing range and not much can be done about it. YES it is anoying , but guess what you'll have to deal with it. And Friend you are lucky that you did'nt get on that hi voltage @ 20KV and higher . again not much can be done and a new monitor WILL NOT HELP THE PROBLEM.

by aceviper

Can you please explain, how would a new monitor not help the problem? I have many monitors in my house, one which is the exact same as this one, and none make the noise but this one? Also the noise doesn't always happen, so I can't see how it would be part of 'normal operation' if it doesn't always happen? It can go a week and not do it, but then do it every day the following week.

All these other comments I've gotten agree saying it's not "normal." Main question for you is how you thinka new monitor would not fix the problem??

by boli

Degauss the monitor 4 or 5 times if it doesnt work then shake vigerously and hit it.
you neva know, the last 2 comments could work

This discussion is closed to new replies.