Discussion Locked

Monitor problems

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a problem with my monitor. When I start the computer, the monitor signal is amber, not green...and I dont hear the post signal beep. I then tried to start the computer again...only to wait until the cd rom lights blinks and quickly turn on the monitor and then I hear the post beep imediately after that and the monitor screen is viewable(green light)...I have tried everything: checked power cords, reseated video card, switched the monitor with another machine and it worked normally...I really would like to stop the annoying pushing of the monitor button to get the thing going....I have pII WINDOWS 2000 with the lastest service pack 3 and direcx drivers

5 replies

by thechas

This does not sound like a video or monitor problem.

I believe that the PC is not getting into POST the first time you start it.

Since this is a PII, it is several years old.

I would start with a new CMOS backup battery.
When the battery gets low, it can cause the BIOS to see improper settings in the CMOS.
This can cause POST to fail, or not even start.

Next, I would re-seat both the CPU and memory modules.

I recommend that you try leaving the PC on overnight, with the monitor off.
If the monitor comes up right away the next morning, I would suspect a system (motherboard) problem.

Chas

by ian boothby

Try turning off all automatic power saving options in the BIOS. I had a monitor that did this - it used to go straight from boot into sleep mode. Go through the BIOS options - there's quite a few settings that could affect it. Some mobo's have a jumper you can set to enable the GREEN mode - this could be an option if this monitor is "new" to this mobo. Good Luck!

by mderancy

Thanx..your suggestions helped me a great deal. The apm settings was turned on in the bios and I disabled it. Now my monitor works fine at a bootup.

This discussion is closed to new replies.