Question Locked

Monitor will not receive signal from computer. I have tried everything.

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have replaced mother board. This system has an intergrated video system. Memory is fine, hard drive is fine, power supply is fine, all other cards are fine, but still no signal is sent to the monitor. Yes it is plugged in, and I have tried several monitors. What next?

10 replies

by thumbsup2

Well, if it's a new motherboard and you can't get the onboard graphics to work, I would suspect the "new" motherboard is BAD!!!

by lcristof

You did try a new cable?! from the monitor to the pc?. laso could be a broken(bent) pin in the pc port or cable end.

by david.wallis

is the pc posting? do you get post beeps?

there are a number of reasons the monitor may not work..

if the system isnt posting -
1) the board could be faulty
2) the cpu may not be compatible
3) the ram may not be compatible
4) you may have the jumper set to clear the cmos in which case it wont post :)
5) the psu might not be good enough, whats the power rating of it?

by mich147

1)DDR3 Patriot Ram
2)I Core 7 processor
3)Gigabyte Ultra Durable 3: EX58-UD3R (MB)

by balge

hi
you did check the BIOS is set to use the onboard graphics?
cheers?

by mich147

In my case: do not have on board graphics card...In the other chap's case... "How does he configure the bios when, for whatever reason, the PC may not be posting,(possibly for the reasons mentioned earlier in this post), or the monitor, expansion slot or graphics card, or cable is bad?

by balge

wasn't replying to you was replying to OP, on autopilot...
It's not considered good form resurrecting old threads btw, easier to start a new one.

FWIW try pressing 'del' next time you're halfway through a 'POST' ...

cheers

by paldebayan

i have the same problem...my monitor does not display anything...but the computer is workin fine....i was readin the posts here...tried out everything...openend and re assembled everything....
then i got angry and slapped on the side of my monitor...and for 5 seconds it turned on...and again the same thing...no display anymore...i tried slapping but it dint work anymore....so i guess its got to do somethng with the monitor....m gonna get it changed tmrw...

This discussion is closed to new replies.