Discussion Locked

monitor will not work after startup

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
How can I reset the HZ on the monitor so it will work after startup with out error message-FH//./KHZ no singnel

4 replies

by valis

that's signifying a problem with either the video card or the cable, not the monitor, i dont think. does the computer work at all?

by djent

Check the specs on your monitor, many old monitors syn at a rate too slow for newer display cards. Boot up in VGA mode and set to lowest res and sync rate possible and work your way up. A sync rate set to high may damage the monitor.

by djent

Check the specs on your monitor, many old monitors syn at a rate too slow for newer display cards. Boot up in VGA mode and set to lowest res and sync rate possible and work your way up. A sync rate set to high may damage the monitor.

by thechas

If you are running Windows XP, you may need a different monitor.

I thought I was having serious video problems when setting up new PCs with XP.

Turns out my old bench monitor did not support the default refresh rate that XP uses.

Replacing the monitor with a newer monitor fixed the problem for me.

Chas

This discussion is closed to new replies.