5 replies
by mjd420nova
A transistor on the deflection circuitry has
fried itself. Thid usually requires replacement
of the board. If you're skilled enough with
a soldering iron, you can replace it. It is
usually mounted to a heat sink so you'll also
need some heat sink compound when mounting
the new one.
by mjd420nova
The capability of the CRT retaining enough
charge to cause trouble is real. I use a small
screw driver and a lead with clips on both ends.
Attach one clip to ground and one to the
screwdriver. Hold the screwdriver by the handle
and don't touch any metal, slowly push the
scredriver under the rubber boot around the
high voltage connector on the CRT. You will
hear a sharp crack, and that should eliminate
that hazard.
by sgt_shultz
sounds like above person knows...
FWIW, from apple support
eMac: Popping Sound Followed by No Video
A small number of eMac computers have experienced the symptom (during startup) where a popping sound is heard and the display remains dark.
Symptom
Possible symptoms include:
1. A popping sound.
2. A flash inside the plastic case.
3. A flash on the CRT.
4. No internal video, however the unit will boot and display external video.
NOTE: These symptoms occur immediately after pressing the power button.
Products affected
eMac
Solution
If your eMac has experienced this symptom, please bring it to a local Apple Authorized Service Provider for repair.
by sgt_shultz
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending