Discussion Locked

Motherboard

0 helpful
15 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

The only computer I have is the one I have just built........and will not work.

It is an AMD 850Mhz with 40Gb HDD, 256Mb RAM, 230V power supply. It has onboard sound. The video card is 32Mb and I have a DVD, CD-RW and floppy drive. When I bootup the BIOS beeps only once and correctly Identifies the HDD, CD-RW and DVD but I just cannot install Windows ME.

Amongst the errors I've had are "SCSI present but not configured at the PCI bus", "Your program has caused a divide overflow Error" and "....corrupted CAB file"

Anyone any idea what is wrong. Can I test the motherboard somehow?

15 replies

by ebob

Is your HD EIDE or SCSI? Is it plugged into the right controller with the right cable? If EIDE, you may need to use a UDMA 66/100 cable (80 wires/40 pins), not the traditional UDMA 33 (40 wires/40 pins) type.

If SCSI (and everything is plugged inall nice), then I believe that you'll need to config the SCSI controller first, before doing anything else.

by searogue

Hi,
I cannot say for a fact if this would actually cause you rproblems, but I do know that for Athlon, you should be running at least a 300 watt power supply. Also, is your HD ATA 100 ? If so, do you have an ATA 100 controller ? From what I haveseen with one of my ATA 100 controllers, it shows up as scsi, maybe your controller is bad.
Just some ideas & thoughts.

Best Regards,

Tony

by otl

One short beep usually means system checked out OK, with the limited checks it makes from the BIOS.

I hope you mean 230W power supply, check the power requirements for the motherboard and CPU.

Have you tried booting with the minumal requirements for a system? 1ea. monitor, video card, floppy drive (with bootable disk)

Is the BIOS configured for the add-ons you have or at least looking for them?

Do you have the Windows ME in the CD-RW? Will not be read in the DVD. Is the bios set toboot off the floppy or CD?

Have you partitioned the HD as the primary DOS partition? Can not load windows to a non-DOS partition. Formated the hard drive?

Tried making the DOS partition bootable? DOS mode only, to at least start the system.

by estebandelatorre

Unplug the DVD and boot the system with the cdrw , the HD (ide?) and a FDD.
Go to the Bios Cmos setup and choose an option like "Restore Default values" or better, move jumper in order to clear Cmos setup from the motherborad (unplug main power first)
One beep in normal in any mother.
Proceed with install with a boot FDD or from CDRW

by ielliott

I would check the compatability between the motherboard and the video card. A friend of mine had problems with an AMD board and I think an ATI card. He was not able to install an OS at all. Kept coming up with errors like the ones you have listed.

by topesblues

The new amd pIIIs need a 300Watt power supply. Anything smaller may give you goofy errors such as the ones that your having and not let you install the O/S or other software.

This discussion is closed to new replies.