Discussion Locked

Motherboard ATA66 adding ATA100 PCI card

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I havea MSI Motherboard which is ATA66 maximum and have purchased a ATA100 drive. I have now purchased an ATA100 PCI card and want to install it. Problem I don't know is, when you install the card and connect the hard disk to it (which at present is the C: drive and boot drive) what is the letter of the drive if I connect the current c: drive to the new ATA100 PCI card. My bios dosen't allow for more than 2 hard disk, CD or zip drives.

8 replies

by cascom

MSI boards, as with most recent main boards,
have 2 IDE controllers on board. Each of
these is capable of supporting 2 drives
(slave & master).
Provided you disable the controllers in BIOS
your ATA100 card will assume the role of
replacement controller. Provided you have
configured the card correctly the drive will
come up as C: drive.
This does depend on how many drives are in
your PC and whether you configure the new
controller as the primary IDE controller.

by peter

Answered part of the problem, but not the whole lot. How do you configure the card as the primary IDE controller. What devices can you then connect to the new ATA100 controller card to keep the faster hard drive running at ATA100.

by tony.colgrove

As the above answer states your motherboard only supports the two IDE channels. When you add an additional controller (even IDE) the motherboard will reference it as SCSI controller. To set this controller as the default boot device, find in the BIOS the boot order and select SCSI. Your motherboard does not detect the drive, but the ATA100 card will (you will see this during boot).
Your C: drive will still be the C: drive.

by peter

These answers don't solve my problem. If I have to disable one of the onboard IDE controllers that then leaves me with only 2 ATA 66 devices off the motherboard and then 2 ATA100 devices off the new controller card. I have 2x hard drives, 1 ATA66 the other ATA100, an IDE CD/RW and an IDE zip 250 drive. So what do I do in this case, which of these drives can I connect to the other connection on ATA100 card so that the ATA100 hard disk runs at ATA100 standard. Also do ordinary cables work with the ATA100 card or only the cable that came with it (the 80 channel cable) I only got one with the card it has two connections on the cable and two connections on the card.

by cascom

Part 2..
Depending on which controller card you have installed..
Consult the documentation supplied with the card and set parameters accordingly.
OR
When you disable the primary controller in the main board BIOS the ATA100 controller should takeup the role.

Devices attached to an IDE controller will communicate at the speed of the slowest device on the data "bus"
, hence if you want 100 MB/sec performance, only connect ATA100 capable devices to the cable.

by peter

Tried that, didn't work. I then reconnected the drives up the old way and booted up to windows with only the ATA100 board in the slot and no drives connected. Mainboard had both IDE controllers active. W2K detected the new board, I installed the drivers. Shutdown, connected ATA100 drive up to card, left on board IDE's both turned on and everything works fine. I now have access for eight IDE devices, just need to upgrade the power supply to handle it.

This discussion is closed to new replies.