Discussion Locked

Motherboard or processor

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My friend has a problem with her PC. I have eliminated most of the hardware, and have tried booting with only RAM and processor (celeron 400) connected to the motherboard, and no POST beeps at all result. Is there any way of testing whether the fault is with the motherboard or the processor without obtaining a good processor or motherboard - don't want to buy the wrong one!!!

N.B.: Have tried different power supplies etc.

3 replies

by dougroswell

Obtain a voltmeter, Check the voltage going to the motherboard. If an excesive amount of voltage or to little voltage is running through the motherboard. It could be your motherboard is shorted out.

Yellow wires should be +12v
Red +5V
Oranage +3V
Black is ground (0V)

Check the voltage with the power on, stickothe volt meter lead down inside the connector while it is connected to the motherboard.

If all voltages are normal, I would look more to the processor, If the voltages are extremely high then I would fear for your processor and RAM, as they are probally damaged as well

Good luck.

by dmiles

- make sure the psu atx connector is securely fastened on the board

- make sure the memory is in correctly

- try moving the memory in another slot

- remove/ reinstall the processor.

- There is no way to check the motherboard without a diagnostic card

Is it possible to try the CPU in another machine to see if it's working

by uziel

in addition to the other suggestions, try clearing the CMOS or remove the system battery for a couple of hours, that should clear the CMOS then try to reboot.
in cases like these it usually the power supply, the motherboard or the processor itself is at fault

This discussion is closed to new replies.