5 replies
by infoguy
by eraser3498
by thechas
1. Tripple check all jumpers.
2. Go through the CMOS memory reset proceedure.
(make sure to put the jumper back to "normal"
3. Make sure the video card is fully seated.
The best way to do this, is to remove the bracket so that there is nothing to stop the card from seating all the way.
(It only takes a few 1/1000" to make an AGP card not function.)
4. Verify that nothing is shorting out between the motherboard and the case.
5. Strip the system back to a minimum configuration(CPU RAM video) and see if it posts.
If so, add in 1 device at a time to locate the conflicting device.
If none of the above helps, then it is likely the motherboard.
Chas
by eraser3498
by eraser3498
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending