Discussion Locked

Motherboard Replacement

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a Gateway P166 tower. I was told by Gateway that this was the maximum processor for the motherboard. I want to replace the MB and the processor, but was told by Gateway that it couldn't be done. How true is this and if not where is the best place to determine a compatable replacement MB? Thanks?

11 replies

by dmiles

Look up the motherboard at the manufacturers site,to get the form factor,AT or ATX,this will detrmine the case size and the possibilities of what boards will fit the case.Then go www.tomshardwareguide.com,which is a good hardware guide
Other siteswww.motherboardsdirect.com
www.sysopt.com/motherboard.html
www.motherboards.org/bios.html
If you plan to use the present case,you will need a board to fit the case and then if the change is made,you only have to purchase the cpu.Unless the computer is under warranty with gateway is the only thing that I can think of for them to say it will not work.
Systems are built with different boards every day.They may be using a certain case,which I doubt,so I am not sure what the case is for them saying this.Ask them point blank why this cannot be done.

by csmith

Len,
As I remember these machines they are mini AT form and can not support MMX processors.
The problem is that virtually all of the new motherboards are ATX.
The best way to go is to sell the Gateway P166 (Keep the monitor, printer, etc.) and buy a new computer.
Another alternative is to buy a motherboard and case, then strip the Floppy Drive, Hard Drive, Sound Card, etc from the Gateway P166.
You are going to have to buy new memory.
The memory speed is a major choke point in a modern system.
I would recommend an Athlon CPU motherboard with DDR memory.
Our users seem happy with them.
Regards, Chris

by vertex

Have to agree with Chris above. If it's not proprietory, then any Socket 7 should fit. You should determine if its AT or ATX form factor. Best to strip the PC, buy new M/b, CPU and casing, saves the trouble of figuring out which is which.

by hiranyaw

You can replace the mother board and processer. i think it's ATX case but still you have to change the power supply in the case too. new motherboards and processer need more power at least 250w's. i think Gateway is right. just get a new computer with mother board and processer every thing except monitor. only think you can use from you'r p166 computer for now is the floppy drive. which is same for last 5 ,6 years. even the cd rom will be too slow.(4x,or8x).

by thedrummer2006

I think most of the previous answers are right but my luck with gateways are they have their own style of motherboard and alot of the older machines had daughter boards which means the motherboard has one slot on it and a small board that plugs intothat slot. Then your add in boards will be installed on this daughterboard. If your trying to fit a new atx motherboard into this case GOOD LUCK! But if you are dying to keep this case and its not a daughterboard type there are the possibilities of retrofitting an atx board in it.
1)Make sure youve got enough power supply!
I would not go less than 350 on a newer atx board.
2)Make sure your keyboard, mouse, serial, and parrallel ports will match up.
3) Make sure your card slots will line up.

Personally I would just buy a $20 tower and build a new one. Lots easier and cheaper. If your buying a new motherboard, your going to need different memory and processor so why not go all of the way. You can still use your old floppy and cd rom's and Hard drives until you can afford a newer FASTER model.
The possibilities are endless.

Hope this helps.

This discussion is closed to new replies.