Discussion Locked

Mouse

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I keep getting "Windows has not detected a mouse...You can attach a PS/2 mouse safely now" dialogue. The mouse is attached and it seems that no matter what I try in the Add New Hardware wizard it can't find it. I try rebooting and nothing seems tohelp.

10 replies

by ann777

The port is probably bad -- which normally means a new systemboard. Hopefully your computer is still under warranty.

You should never attach any external device (except USB devices) to a powered on computer. If the external device pulls powerfrom the systemboard, then there's the possibility of shorting out the port. External devices that draw their own power (printer, monitor, etc) are usually okay to swap with the system on... but mouse/keyboard and any serial devices -- I do not recommend connecting when the system is on.

by ann777

With the system off, you can re-plug in the mouse and prop it up with a small box (ie, a paperclip box) to make sure the plug does not angle incorrectly. It's worth a try anyway. Good luck.

by blandmesser

Try switching this mouse out with a known good mouse from another PC. If the known good mouse does not work, it is time to look at your motherboard. If the known good mouse does work, put the mouse in question in the other PC. If it does not work there, throw it away and go to Circuit City and pick up a new one.

by paulp

Look at the mouse connector to see if any of the pins are bent or missing. I have successfully straightened out bent pins, but they can get fragile and should be plugged and unplugged as little as possible.

by cowen80194

Are you using a Serial mouse on a PS/2 port with an adapter/converter?

I have found that most cases if the adapter does not come with the mouse it wont work.

Also try looking at the PS/2 port did you add this or did it come with the MB if you got it from another board the pin out of the head connector may be incorrect for that MB.

Both of these anomalies have occured in my experience trying to free up a serial port and switch to a PS/2 port on a test system I have. I was able to find technical information on the PS/2 pinout on the manufature's web site and I had a good PS/2 mouse to try after I reconfigured the head in plug.

Good luck with this suggestion.

This discussion is closed to new replies.