Discussion Locked

Mulitiple Nics

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Will having 2 nic cards in an NT 4.0 server help file transfers. If so explain what to do with the IP's

5 replies

by 4u21der

Q: Will having 2 nic cards in an NT 4.0 server help file transfers?

A: No, this will not increase the transfer rate between nodes on a network.Unless you are using some type of load balancing software or are in a clustered enviroment. The cards alone will not help.

Q: If so explain what to do with the IP's?

A: Each Netcard allows your machine to participate on different broadcast domains.
This allows your machine to have a "foot on both sides". This way you can acces 2 different networks without having to setup static routes in a router. This is a typical configuration for Proxy servers and firewalls. It is also a very popular procedure to use in enviroments that need failover systems.

Hope this helps.

by bigduck

The first answer is correct. A little more detail may help you. NT 4 will allow you to bind a single IP address to a NIC. If you need to add another NIC to the server to improve performance then you need to split half your machines to each NIC. If the machines are all connected with a switch then you do not need to change anything, just plug both NICS into the switch. If you are using a hub then you will need to get another one, one for each segment. For example. If your current IP address at the server is 192.168.1.254 (use your current address) then the other machines connected to the server will have IP adresses of 192.168.1.x. and a gateway of 192.168.1.254 Add a new NIC to the server and make its address 192.168.2.254 and then the machines connected to this NIC will have to change their addresses to 192.168.2.x with a gateway set to 192.168.2.254. The under the network properties for the TCP/IP protocol go to the advanced setings tab and enable the "IP forwarding" option. This will allow the machines on each segment to talk to each other with the NT server box acting as a router. Try to put the mahines that talk together the most on the same network segments.

This discussion is closed to new replies.