4 replies
by tduval
Check drives on another computer.
If ok, then you experience a problem with ide cable, drivers, straps.
by william jay
Howdy,
Check the things mentioned in Answer one, but check the Jumpersfirst, (master, slave, cable select), then watch to see that both drives are recognized properly by the BIOS at boot time . . .
by blaine moore
First, reboot and go into BIOS set up to see if they are recognized there. If so, then the problem is OS-related. If not, then I would check to make sure that your IDE cables are securely plugged into both the CD drives and the MOBO, that you havepin 1 (w/the red stripe) entering the correct side of each of the female sockets. Also make sure you have the power cables hooked up correctly (which you can check just by trying to open the CD drive when the computer is on, whether your OS recognizes it or not!). I've had IDE cables go bad on me so replacing that can sometimes work as well.
Try a boot disc and see if you can get access to them that way.
by sgt_shultz
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending