Discussion Locked

My CD ROM is missing from Device Manger

0 helpful
17 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
How can I get my cd rom back?

17 replies

by opatzg9

Hardware problem diagnostics:
does the door open/close on pressing eject?
Shut system down, open case, ground yourself to metal case by touching it before anything else in the case.
IF No, open case and reseat power cord.
If Yes then reseat cable both at motherboard and cdrom.
power back on. Is it ok now?
No - might be time to consider new cdrom.
Did this just start to be a problem?
You could try a new cable but cd rom drives with a cable are around $29 for a 40 speed and the cable is $5, you choose how long you want ot spend diagnosing and whether $34 is the probable outcome.
Good luck

by tonya

I have done all you have suggested without any luck. The strange thing is I can boot from a Win95 disc, Load the driver and then hit the drive from the prompt with the correct drive letter.

by dave.osborne

Have you done a virus scan lately? I would update my AV software and definitions to see if that is causing the problem. Did you do anything recently and when you rebooted it just stopped working? Do you have another computer to test the drive in and vice versa another CD drive to test in that PC (borrow a friend's PC)? While you were inside the computer, did you check to see if maybe the jumper had come loose? Did you add any other hardware recently which needed to be plugged into the power supply (maybe you are over-running it, and it chooses to shut down the CD-Rom, which could be the case for it working in DOS since the new hardware (if any) only needs to draw power once windows starts). Have you tried a different config, making the CD the slave on one of the IDE controllers or even choosing cable select, if that is an option.

Hope this helps.

-Dave

by dave.osborne

so you tested the CD drive in another PC already and tested another CD drive in your PC, that was really quick in about 10 minutes

by thechas

Many times, Windows will not recognise your CD drive until you install the IDE bus driver for your motherboard.

I have seen both software installs and Windows Updates remove the IDE driver, and require a re-install.

You can try removing all 3 IDE controllers form device manager, and allow Windows to re-install the IDE driver itself.

I prefer to download and install the latest driver from the motherboard, or chipset manufacture.

If you don't know what chipset is on your motherboard, try either of the following:
www.belarc.com (Belarc Advisor)
www.sisoftware.com (Sandra Lite)
www.motherboards.org (MOBO ID tools)

Chas

by lyallaust

Try booting into safe mode and go into device manager. You may see more than one CD device listed there. Delete them all, and reboot.

I'm not sure why this works, but i have noticed that safe mode tends to show up a lot of inactive devices, so draw your own conclusions.

by tonya

Sorry for the delay :Answer 5 did work and all is fine now. Thank You for the help...

This discussion is closed to new replies.