11 replies
by fcui21 Accepted solution
by ozi eagle Accepted solution
Hi,
Take the hard drive out of your old computer.
On the label there is a diagram of how to set jumpers. It will be in either the CS (cable select) or MA (master) position. If the new computer has an IDE drive, change the jumpers to be in the SL (slave) position, then connect it to the second (middle) connector of the ribbon going to the new drive. Connect power.
If the new computer has a SATA drive then you can leave the jumpers as they are, but also take the ribbon canle from the old computer as well. Plug this into one of the IDE connectors on the motherboard.
Another way would be to purchase a hard drive caddy and run it from a USB port. NOTE the jumpers must be set for master.
Herb
by fcui21 Accepted solution
Both of your replies are full of information that I am sure I can take advantage of. This will allow me to work on this little project of mine this weekend. I will reply if I get stuck!!! LOL
Thanks again.
by pringles86 Accepted solution
by fcui21 Accepted solution
and it still didn't work. You stated "Another way would be to purchase a hard drive caddy and run it from a USB port. NOTE the jumpers must be set for master."
I bought an external hard drive enclosure/caddy and installed it accordingly and connected the USB to my PC with windows XP. It recognized the new hardware via USB but it says "memory free 100% of 31.5 GB". I try to access the drive where the USB is connected and it states "The disk in Drive E is not formatted. Do you want to format it now?". If I click on yes it states it will lose the data. How do I make this work so I can retrieve the data that's on this HDD? Please let me know soon because I need to know if I need to return this new piece of hardware. Thanks in advance!
by fcui21 Accepted solution
by ozi eagle Accepted solution
Hi,
Sorry about the delay, but I've been on the road.
Check whether the disk is recognozed by Windows.
Control panel - administrative tools
Computer management - Disk Management
Does it appear here? Is it being recognized?
Herb
by starwin33 Accepted solution
follow these steps:
take out your old harddrive from that piece of junk your trying to dispose or try to giveaway that to some charities. (lol)
if you have a new pc now, plug it in there, if you don't have an extra IDE cable, use the one that connected to your CD or DVD ROM, just make sure to set that old HD as slave (refer to jumper settings on your harddrive, its in there), that old HD will be automatically detected by your new pc.
when the windows start up, open My Computer to check if that old HD has been installed, if you haven't created a partition, it will appear in your pc a two harddrive, one is "C:" the other one is "D:"
by fcui21 Accepted solution
by ozi eagle Accepted solution
Hi,
The problem here is that Win98 cannot read disks formatted in NTFS, like XP uses. You will need to find an XP computer to plug your old drive into.
Also if the cable you are using has MAster / slave connectors, make sure your drive has the jumpers in the CS (cable select ) position.
Herb
by fcui21 Accepted solution
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending