Discussion Locked

My Hard Drive C has Crashed

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

RUN WINDOWS 95B Hard Drive C do not boot-up I can get a: and I chk bios and it chk all rigth.
My Hard Drive C has Crashed. Has important Documents on it. What software
can you suggest to remedy this. Or do you have any other suggestions.
RUN WINDOWS 95B sand mail to FFONTAN1@oncorgroup.com and ffbb@earthlink.net

13 replies

by timthetoolman

Hi,

From you subsequent comments posted on the 14th.... Yes, I recommend the software posted in my answer.

It will be up to you as to whether your data is valuable enough to warrent spending the money, but you WILL get all the data back that hasn't been irrevobably lost.

If you persist in playing with the drive by doing stuff like

a:\sys c:

Then you're risking further damage to the drive.

Its up to you...
Oh, I believe that the above software supplier has a free download thatwill allow you to see what could be recovered... But not actually do it.

That will show you what will be possible before you decide to spend any money.

Also, you'll need a new disk to move the data to...have you bought one yet?

Cheers,
Tim.

by thechas

Does the drive spin up and run it's self test at post?
Does the BIOS recognize the drive?

If the answer is no to both questions, your best hope is a data recovery firm.

Alternately, download 200 ways to revive a dead hard drive from the download section of Tech Republic.

If you get the drive to respond, back up the files right away.

by mike (from canada)

Make sure the parameters you use are correct for your hard drive. If it says 1000 cylinders on the drive, dont use 30000 cylinders!

Once you done that, boot from the floppy. and try typing C:. If you can do that, then your partition is OK. if not, then run FDISK and create one.

Once C: is accessed, type DIR or a command that does file I/O to C:. If you get an error, then the drive is not formatted and there is NO chance to get data back.

You SHOULD back up your data as soon as you seeany.

If you get an error when trying to create a partition, then the settings for your hard drive are incorrect.

by highlander718

usualy it works if you are using a second configured harddrive as master and the current one as slave (using either cable select or set the jumpers). You can also take out your hardrive and install it on any other PC as slave and recover your data. Most of the time the controller is the one that fails not the harddrive.

by ffontan1

"Hard Drive Failure" The 1.7g ibm drive spin up and run.
I check the BIOS inform. and it all check all ok.
then go on booting then I get "Primary Hard Drive Failure" and black screen.

If I do this, boot from the floppy. and try typing C:. Ifyou can do that, then your partition is OK. if not, then run FDISK and create one. will it delele my data. see below

I am having Primary Hard Drive Failure.
Can you recommend step at this poin Software or
Technique to bring this drive backup.
I'am RUN WINDOWS 95a Hard Drive C do not boot-up I can get a "Primary Hard Drive Failure"
Has important Documents on it.

by pgcarter

Check all cables and connects related to drive. In the bios use auto detect. if there is a loose connect the bios may be just showing you old info, so autodetect to be sure.
Try to scan for virises, next try fdisk /mbr. If that doesn't work try to read the drive an another machine as mentioned.

This discussion is closed to new replies.