Discussion Locked

MY HD READS ONLY 2 GIG(on a 10 gig hd)

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
i recently have done a few setups for 2 pc.i notice that all of my components works beautiful , but on both pc's i read only 2 gigs and one is a 9 gig and the other is a 10 gig HD'S. i'm running win 98 and is not like nt4.0 that you can keep creating other drives if you have more space.how can i set this to its full drive space?without loosing data

9 replies

by george_koitchev

I think this is rather a problem of your BIOS. Check out if the disks are reported as 2GB at the startup test. If so, your only chance is to upgrade the BIOS of the MB.Then you will get at least 8.4 GB as a maximum possible disk size. Or 15 GB - depends on the MB's. If that doesn't help, then the MB's are too old to support disks of that size

by chocomenta

If you run the command FDISK check pressing F4 if you have partitions not formatted if this is the case FORMAT them.
Also I would recreate the partition selecting the option of the SUPPORT for big HD and just after that reformatting the all HD.
Hope it helps,
Regards,
Paolo

by beermonster

Ending up with a 2 gig partition usually means that the initial setup (IE fdisk) was done with a version that does not support fat32, or fat32 was not selected. create a recovery disk from your98 machine, boot off it and select cd rom support. run fdisk, and you will be prompted for whether or not to activate 'large disk support'. If you say yes, then fdisk will use fat32 rather than fat which will utilise the entire disk. format as usual and then install. Hope this helps...

by grump

Lets say you by chance initialized the hard drive using fat 16 which has 2 Gig Limit.. and you did not partition the rest of the HD setting up an extended partition..

Boot to dos and run fdisk again view the partition table as check if it is fat 16.

Setup an extended partition and then the logical drives .. You will still have 2 gig limits on the logical drives.. you will have to format each drive..

If you are familure with Symantic GHOST you could image the drive to a file on anotherHD and then image HD from a file using the fat 32 switch.. This will put things in align with what you want .. No data loss and being able to utilize the whole drive..

If your system only supports 8 gig, you will have to use a drive overlay such as EZ Drive or HDM from ONTRACK..

Hope this helps ..
Keep smiling and nobody can guess what you are thinking!

This discussion is closed to new replies.