Discussion Locked

My printer has no power lights on?

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My printer is plugged in but is not recieiving any electity to power it. I would like to information on trouble shooting faulty wires or jacks connected in side my H.P. desk jet 882 C printer. I can not figure out how to properly open my printer up.I acn not afford to buy another printer at all. Please help me with suggestions.

8 replies

by eandj

If any one is willing to donate a printer for my home school, plaese feel free to do so.
eandj@westelcom.com

by thechas

First, use an ohm-meter, and check for continuity in the power cord.
There should also be nominal continuity at several hundred ohms across the power terminals on the printer.

There are numerous ways that printers are assembled. So I cannot give you specific instructions. If there are no visable assembly screws, carefully prod and pry at the seams of the plastic pieces. On many printers, the upper case snaps onto the lower case. Some have access openings in the bottom to release the snaps.

Check for broken wires, fuses, and the power switch itself along with the cable that connects the switch to the circuit board.

Unfortunately, unless it is a broken wire, or a blown fuse there is going to be little you can do to repair the printer yourself.

I have found good deals on used printers at www.comprenew.com
They have had HP printers for under $50. Of course, it cost me more for the ink than what I paid for the printer.

Good Luck

by thechas

You might also try powering up the printer without the printer cable connected.
A problem with the port or printer cable can prevent printers from powering up.

There is also a guide on HPs web site on how to run the self test for most of theirprinters.

This discussion is closed to new replies.