Discussion Locked

My server will not reboot!

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I came in this morning to find that the air-con in the server room had failed. Three of the four servers there seem to be fine but one will not reboot having shutdown. When restarted it runs POST, memory checks are ok, all three RAID drives are detected and seem to check out but then I receive a message saying 'boot device not found- Press F1 to reboot or F2 to enter Setup Utility. The server is a Dell Poweredge 2550 with three 40GB RAID HDD. Can anyone help?

5 replies

by vinnyd

The drives may be a too high a temp for them to read correctly.

I had a server once that did this.

When I put my hand on the case next to where the drives were, it was too hot to hold my hand there.

I took the case off the server and used an outside fan to cool the system down to the point where I could put my hand on the hard drive (it was too hot to touch at first).

Then I turned the server back on and it booted up.

by ann777

Go ahead and press F2 and enter setup.

It is possible (in fact I just experienced something similar) that the warming/shutdown situation has drained your CMOS battery. Enter setup and confirm your hdd settings. Our servers have SCSI drives and because the CMOS battery did not retain drive settings, the systemboard defaulted back to IDE "auto detect" and could not find the SCSI drives. I replaced the CMOS battery (after verifying with a multimeter) and reset the CMOS and all was well afterward.

This discussion is closed to new replies.