Discussion Locked

NEC Multisync FE700 monitor faulty

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a faulty NEC Multisync FE700 monitor. The vertical has shrunk and also there is poor definition on the screen. I mean that the contrast is very poor. What kind of fault could cause both of these problems?
I am a technician, so I am able to solder and test components etc. Any help would be very much appreciated!

3 replies

by estebandelatorre

To avoid any driver problem, set your display to VGA PCI standart.
If you have poor definition & contrast, the tube may be low. You should find a preset in order to change the contrast level. However this may change the % color levels, due to a LOWrating tube.
Thge poor definition can came also from an out of focus setting. Find it near the flyBack and adjust it to the best definition posible.

Good luck

by better_be_good

Thanks, but it isnt a driver problem and the contrast/brightness levels have been adjusted. The screen's height has shrunk and even when adjusted to full screen height it still doesnt fill the screen. This is why I'm ruling out a faulty tube, because of both problems happening at once.

This discussion is closed to new replies.