10 replies
by solorioeddie Accepted solution
by santeewelding Accepted solution
For, lo, these 19 months.
Now, you come here, from there, where you were "supervised".
You look for more of the same?
Start new.
by exploytit Accepted solution
by santeewelding Accepted solution
Whether you are young and dumb, or old and stupid, you sound like you only want to resume doing what got you into straits in the first place, as in, pictures and video.
I, for one, would not admit what you admit. I would admit only that I need to put it behind, and be of fresh value to the rest of us -- unless you value only you, and, screw the rest of us.
by technocrat25 Accepted solution
1. Make sure everything is plugged in correctly and the power supply switch is on.
2. Make sure all the hardware is seated properly.
3. Check for Beep Codes.
4. Disconnect all non-essential components.
5. Reset CMOS.
6. Check to see that there is a fan plugged into CPU Fan Header.
7. Test the ?on? switch.
8. Make sure standoffs are not shorting out the motherboard.
9. Make sure the heatsink is contacting the core correctly.
10. Swap out parts and test for what is causing the problem.
by jbencsik Accepted solution
I don't know what Santeeweld is on about but it sounds like he has an ax to grind as he offered up absolutely zero helpful information.
The guy has a dead computer and would like to retrieve data off it. It doesn't sound all that nefarious.
Of course, more information is needed. When you say this computer doesn't start, do you mean it's not doing anything at all? As if it's not getting power? Or does it start up but all you get is a black screen or something.
Details will get you everywhere.
by older mycroft Accepted solution
http://www.overclockers.com/forums/showthread.php?t=266936
The checklist is halfway down the page .
by oh smeg Accepted solution
And has not been used for a while as apposed to someone trashing the OS is that the BIOS Battery has gone flat and needs replacing.
This is a Coin Battery on the M'Board and is generally a 2032 Type Battery. To replace this you need to remove the cover from the system disconnect any Power Leads that may be plugged in and push the Battery Lock back to allow it to pop up and be removed. Replacement is the opposite of removal but make sure that the new battery goes in so that the Flat Face of the battery faces away from the M'Board.
After the battery is in place plug in the Mains Lead and push the On Button. When prompted press the Specified Key to enter the Setup and set the BIOS to the Performance Defaults and set the Data & Time to current settings. Save the changes as you exit the BIOS and see if it starts now. ;)
Col
by jordoncomp Accepted solution
by ic-it Accepted solution
1 person was teasing him
2 offerred helpful advice (3 counting you).
2 others responded to other posters.
what is the old song "well 2 out of 3 ain't bad"
;-) :-)
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending