8 replies
by tlippert
Built four machines for a shop just like yours two months ago. Specs were 5 PCI, 2 ISA. Finding the boards was like searching for the holy grail. Found them at
http://www.addonshop.com/cgi-bin/showitems.cfm?ItemID=79&CategoryID=1
Hope this helps.
by guruofdos
by csmith
One of the boards we use is the EPOX 8KTA3.
It has an ISA slot, and is a good motherboard.
My main question is, why not adapt the ISA design to PCI?
Except for the PCI latency problem, this should not be so hard to do. (They have managed to change Printer and COM cards. Also very slow cards.)
A side question: Why are you not using assembler In and Out commands?
You can access it from C, and they are not that complicated, that excessive programming time is consumed.
Does this board use polling, instead of an interrupt?
Why do you have to have ISA?
Is the 8255 so slow, that you can't safely buffer it?
Of course the last question is, who/where is the engineer that originally designed this board?
These questions are also ideas.
Regards, Chris
by guruofdos
by csmith
3 or 4 per year? Ouch! No R&D budget on that.
The problem of the single slot, is not really a problem, because you can use old Packard Bell ISA Extender Cards. (Remember the old Packard Bells had only one ISA Slot with a Riser Card plugged into it.)
The assembly code was 99109-913-623, and the PCB code was 93004-916-410.
These things look like the old 30 pin SIMM extenders that were sold for 386 and 486s, only for ISA.
The card is standard height, but the daughter cards will be at a right angle to the standard positition.
Are you set up to modify a standard case?
How much processor (CPU) power do you need?
Another option is to buy a bunch of used MBs.
Regards, Chris
by guruofdos
1GHz is ample...thats for the video capture and replay side of things. Tha actual I/O and hardware control will run on a 486 DX33!
I have countless extender boards (PB, IBM, Elonex) and can manufacture them if necessary, so I guess that is probably the best option as regards extending slots. My preferred alternative (on similar lines) is to make a simple proto ISA card with the 30 or so relevant lines (Address, Data, IORW etc) buffered with some standard 74 series TTL Buffers brought out on an IDC cable. Fit the ISA cards on a 4 Slot passive ISA backplane in a separate case and have a matching Proto card to take the IDC cable and convert back to ISA pin-out. Used or second-hand mobo's are out as the systems are for military and police use so have to be subject to pretty stringent QA checks. Thanks for the advice though...my gut feelings were drifting that way so that's my probable way forward.
by csmith
Cancel the idea about using a Packard Bell riser card.
The daughter cards would point off of the end of the Motherboard. (Down in a tower case.)
Another idea would be to increase the efficiency of the program, instead of using a more powerful CPU.(You would be burned at the stake, for expressing this idea, at Microsoft.) The question is of course the available time, and the economics of it.
Regards, Chris
by guruofdos
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending