Discussion Locked

Need to convert NTFS to FAT32

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I need to uninstall Windows XP Pro from a Laptop and reinstall Win 98SE. I'm unsure how to convert an NTFS drive back to FAT32. HELP!!

10 replies

by timwalsh

There is no conversion from NTFS to any other file systems (without using third party software. You must reformat the drive. Your best bet is to boot from a Win98 boot disk, furn fdisk to delete existing partitions, and recreate the DOS partitionsyou require. When you reboot, you can reformat the drive as FAT32.

by jackofalltech

If you don't need to preserve your data, the previous answer is correct. Otherwise buy a copy of Partiton Commander (sorry, no URL - go to Best Buy or similar). It can convert back and forth with no data loss.

Ralph

by pk88400

If you really need to preserve ur data (hope you DID save them anyway) I'd suggest
www.powerquest.com
look for their tool Partition Magic - I managed to convert NTFS to and fro FAT32 or FAT.

Good luck!

by admin

just write it to another drive first and then fdisk and format. It works better the clean way over the long haul IMO.

by philip.hughes

Thanks for the suggestions. I don't have any important data on the drive but I wasn't sure fdisk would work in this case. I checked on the Microsoft Tech Net site and everything I read told me that it was not possible to revert an NTFS drive back toFAT16/FAT32. I'll give it a shot and see what happens. Again Thanks.

by rsanchezp

Mmmm...never heard of a third party software that is able to change your file system from NTFS to FAT16/FAT32.

by jim phelps

If you don't need to save any data, then this is a no-brainer: FDISK the drive, remove all partitions (except for any "service" partitions), then start over with FAT32.

I would never upgrade ("downgrade"?), if I wasn't worried about saving my data. I would ALWAYS wipe the drive and start over. You'll get the best results that way.

by nickscomputerfixit

I use this Debug routine to completely remove ALL from an existing HD. Doesn't matter wheather its NTFS, FAT32, FAT, Linux, or whatever...

Insert WIN98 boot disk.
Boot to A: Prompt
Type in DEBUG [enter]
Machine displays a dash
-
Now type inthese lines in sequence...
f 200 L1000 0 [enter]
a cs:100 [enter]
mov ax,301 [enter]
mov bx,200 [enter]
mov cx,1 [enter]
mov dx,80 [enter]
int 13 [enter]
int 20 [enter]
[enter]
g [enter]
quit

Good disk wiping...

by chetanpanse

Hi budy.
If i am not wrong you can use Partitation magic 7 or higher to convert ntfs to fat32 without formatting it..try it out.

This discussion is closed to new replies.