Discussion Locked

Network cabling using a CAT5 cable

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
How do you use a sequence to crimp/punch a cat5 cable between a 16port-100mbps switch and a patch panel?

5 replies

by vinnyd

You can buy patch cables very cheaply. So why make one.

A switch is usually connected using a patch cord (straight thru cable NOT a crossover) from each live connection on the patch panel to a port on the switch.

A cross-over cable is only used to connect 2 switches or hubs together.

I always try to keep the cables from the patch panel to the switch or hub as short as possible so that it is easier to troubleshoot a bad connection or re-arrange the network configuration.

by wcmiller

Pinouts can be found at the Cabletron web site, link below. There are even color codes for your convenience. You should have a tester available that will check to CAT5 specifications, otherwise you don't really know what you've got. It is satisfying to get a "green light" on the tester and know that you've succeeded. Happy cabling!

http://www.cabletron.com/support/techtips/tk0231-9.html

This discussion is closed to new replies.