Discussion Locked

Network Card

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
How do I install a network card?

7 replies

by paulfr2

Remove the cover of your computer - get a screw driver - unscrew either the cover slot over the PCI Slot or the ISA Slot on your motherboard.

After sliding the card into the slot, screw it down tight. Connect the RJ-45 Cat5 Cable to the Network Card and put the cover back on the computer.

Turn the system on and make sure you have the drivers diskette or cdrom handy because Windows 9x/NT/2k/ME will ask for it.

Install the Client Software (i.e. Client For Microsoft Networks), protocols (i.e. TCP/IP or NETBEUI).

Reboot and you should be connected to the network.

Goodluck,

Paul

by scramer

Everthing that Paul said. Make sure that you are grounded before you touch the insides of your computer or your card.

A good link that gives detail and shows pictures is located at http://www.homepcnetwork.com/ethernet1.htm

If you do not connect, make sure your card is plug and play. If your card is not plug and play, then you will need to make sure that the DOS settings (IRQ & input/output)are the same as the windows settings. You can look at the windows settings from the Settings > System > Control Panel > System Settings > Network Adapters > Properties > Resources. Compare that to the DOS (reboot to a DOS prompt, run setup from your disk/cd and it will show you the settings.)

Sheryl

by faraz67

To install a network card is very easy. Obviously you first have to insert the card inside the casing of your computer system in the appropriate slot of your motherboard (check the network card manual) and then you have to install the drivers from the CD provided eith the network card and follow the instructions so either you can install in this way or if you are using WIN98 or later version then the operating system will definately help you.

This discussion is closed to new replies.