Question Locked

Network Setup Wizard

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a wireless network connecting 2 pc's. I had to reset the network using the Wizard (Win XP Pro). I used USB drive to connect the second pc and received a message asking "Do you want to add this computer to the wireless network 'ABC'
The problem is that my network is "XYZ".
Any fixes to connect to the correct network? Thanks in advance.

5 replies

by older mycroft

That required you to use the USB drive to connect it?

Usually you just run the network wizard on every machine that will be in the network.

However, if you RESET the network using the wizard without paying attention to the settings pages, the network will have reset itself to the default network name of "ABC".

You'll have to run the wizard again from the start on the first machine..

OR

..change the network name on the second machine to "ABC".

[i]For better results, try to run the network wizard on [b]BOTH MACHINES SIMULTANEOUSLY.[/b] That way you can ensure both systems have identical settings/names.[/i]

by cg it

I find the wizard does more harm than good.

Setting up a workgroup between 2 or more computers on the same lan is the same whether wired or wireless. I find configuring everything manually works a lot better than the wizard. That and you know how it's setup, therefore it's easier to troubleshoot if there are problems.

by seanferd

and allow some sharing yes? (Haven't done this but once or twice, but seemed painless.)

Router would have them on the same subnet and what, no?

AFAIK, Old Mycroft is right, the only time I needed a "setup disk" was to connect a W98 box to the network.

by ogy16v

What to do:
1. When you hard reset your router it's settings go to default, what means you have to set up your router once again.
2.When this is finished set up your wireless connection on both of your computers
3.Make sure simple file sharing in folder options is checked
4. That's it!

This discussion is closed to new replies.