Discussion Locked

Networking with 2 ISDN lines

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

A Client has two different locations with
ISDN lines installed at both locations. They
wish to connect the two locations with routers and the ISDN lines. (ex. at one loc.
they enter an appointment date. This set
appointment date should be transferred over
to the other loc. using ISDN and router)
My question is this. Is there a way to get
the routers to talk to one another and if
so how do u do it ?

3 replies

by stillatit

WARNING -- before you do this, consider the cost per channel of an ISDN phone call between the two sites. Setting up and running this type of routing can be expensive. Making a mistake which results in the link staying up for days can be VERY expensive.

A lot of the detail will depend on the make and model of the ISDN routers your client has. Assuming Ascend Pipeline or similar, these are the rough instructions:

Iin each router you need to set up a demand dial connection to the opposite end. You will need to specify the phone number(s) and password needed to log into the other end.

You then insert a static route pointing all traffic for the subnet on the other lan to the dial connection for the router for that lan.

Other things that MUST be set up include:
Timeout before channel is dropped.
Utilization before a second channel is added (if allowed).
Utilization level and time before a second channel is dropped.
Filters to make sure that RIP and other broadcast trafficdoes not reset the timers on the link (otherwise these will keep the link up ALL THE TIME)

On each computer which will access the remote lan (or on the default router for the segment) put a static route for the remote lan pointing to the ISDN router (outgoing).

All normal IP routing rules apply:
Your routers must each have an IP address and subnet mask appropriate for the LAN segment it is attached to.
All IP addresses must be unique.
The LANs in the two location must use different IP address ranges.

I cannot stress enough -- this setup has the potential to cost thousands of dollars per month! Be careful setting it up, and watch it to make sure that links drop as expected. Users must be educated to not leave running applications that talk across the link.

Good luck.

This discussion is closed to new replies.