Question Locked

new 2.5 HDD in encloser

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi
I have recently bought a new WD120 2.5 HDD and placed it in a A Plus USB encloser. When I plug it into my computer running Winxp Home it Identifies that a USB Mass Storage is there but does not assign a drive letter and it does not appear in the list under my computer. I beleive that the drive needs to be formated but how?

11 replies

by hal 9000

And take off the Jumper then place the HDD back into the enclosure making sure that's it's plugged in correctly and then try again.

These drives don't take to kindly to being set to Master or CS when fitted to a USB Enclosure.

Once you have that sorted out it should install a Mass Storage Device Identified as a WD 120 GIG HDD which you can format through the Computer Management Console.

Col

by sgt_shultz

you might have to initialize the disk in disk management

by brmccart

Reopened the case looking for a jumper but the drive plugs directly into the usb interface (for lake of better terms) with no luck.

by hal 9000

There are still 6 pins not used and they should have one jumper on them. Well in every case that I've ever seen of a IDE Drive put in an IDE to USB Enclosure this is the case when it's not recognised by the XP Installer when it's first plugged in.

Col

by hal 9000

http://tinyurl.com/2p8ezd

[i]I know that it's not a great photo but try taking one on things this small with a digital camera but even though it's not great you can see what I'm talking about.[/i]

You'll see 4 pins on the right hand side of the socket unused on this particular Seagate HDD to the Interface there will be a jumper on one pair of these pins. If you remove it it should work without a problem although you'll have to go into Computer Management then Disk Management and Format the Drive from there.

But when you plug in the USB Enclosure you should be told that you have a Western Digital HDD present of whatever size it is before the drive gets mounted.

Col

by jamesatmaisonverre

Is it possible that it is showing up in my computer as removable storage as opposed to a drive?Did you install drivers before plugging it in?Does the drive work inside the cpu without the enclosure?Have you tried it on another pc?
Ps.sorry about all the questions

by bobby7890

I found a similar situation with a 2.5" HD I mounted in an enclosure. The problem I had was that when I plugged the drive into the USB ports on the front of my PC case, it would acknowledge that something was there, but it would not mount it or install the drivers. The problem was power. Typically, front mounted USB ports do not supply enough power to spin the drive sufficiently. When I plugged it into a USB port on the back, it powered on, loaded drivers, and mounted as a local hard drive. Try a different port.

by mgzsolt

PartitionMagic did the trick for me. Creadet a partition on it and that was it.

This discussion is closed to new replies.