Discussion Locked

New Hard Disk For Older PC

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have an old Pentium III 450 mhz PC which I gave to my nephew for school work. We need to but a new hard disj for the old pc since he's running out of disk space for his projects. What type of Hard Disk would work with this system?

4 replies

by zaferus

A 60 or 80 GB standard IDE drive should work fine, and be inexpensive.

If it doesn't see the disk properly you may need to update the system board BIOS.

by thechas

I posted this to both of your questions:

Hello,

You only need to post your question once.

Most peers who answer questions check all of the topics they are knowledgeable in.

Anyhow, you need an EIDE or IDE hard drive.
The BIOS on the system might not recognize drives larger than 40GB.

If you want to install a larger drive than the BIOS will recognize, you have 3 options:

Get a BIOS update from the system or motherboard manufacture.

Use the hard drive manufactures BIOS overlay utility.

Install a PCI slot IDE controller.

Of the 3 options, the PCI IDE controller card is the best option. While it will cost more, you will get the full advantage of a newer hard drives faster data transfer speed.

You can often find retail hard drive kits with a drive and a controller card.

Chas

by toivo talikka

I have upgraded a couple Dell Optiplex Pentium II systems from 4GB to 40GB hard drives without problems and the system became considerably faster.

Some older motherboards, like Gigabyte GA-5AX only recognise hard drives up to 32GB in which case a jumper needs to be used to limit the capacity to 32GB. Your Pentium configuration may be all right anyway.

If the PC has space for a second hard drive, connect it to the secondary IDE port where your CD drive is as a slave - either change the jumper to 'Slave' if the jumper in the CD is in set to 'Master', or set the jumpers in both devices to 'Cable Select'. Your original hard drive will remain in the primary IDE channel, format the second drive and move the data files across.

If there is no space or no power connections for the second hard drive, you will need to re-install the operating system or clone the original hard drive to the new hard drive using e.g. Norton Ghost as a disk-to-disk copy, connecting the second hard drive temporarily to the IDE cable where the CD drive normally is.

by hal 9000

The Chas is quite right any IDE 40 GIG drive or what are now called PATA should work without a problem though you may have to set the jumper on the drive to the Slave position and not rely on the Cable Select position that is the current Factory Default as the IDE leads may not support the Cable Select option. You may also need to alter the jumper on the existing drive to Master as well.

Incidentally the Gigabyte P11 M'Boards with the latest BIOS will normally only support up to 60 GIG HDD but because these are no longer available you should go with a 40 GIG unit, not sure about other BIOS versions but that should be a good reference point.

Col

This discussion is closed to new replies.