Discussion Locked

new hard drive

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am adding a second hard drive and want to make it my boot drive running windows 98se and keep my current apps that are on my current hd. What is the easiest way to do this?

7 replies

by dmiles

First set the pins on the new drive to master,see illustration on drive,set second drive to slave
You will need to check the make sure your BIOS will support the if it is a large hard drive and the computer is over three years old,then you will want to update the bios
You will need to remove the operating system from the old drive,check to see if you save the install files by looking in Add/Remove programs,uninstall the Win 98SE
You may want to disconnect the old drive from the ribbon cable and then use the Startup disk and partition and format the new drive using option to run setup w/cd-rom support.a crude sort of way but you are trying to get around detecting the MBR on the old drive
Once you have the new drive setup reconnect and you should not have lost anything other than the OS
Check the Bios at startup to make sure drives are being detected,by looking at configuration and setting to AUTO

by vinnyd

Use Symantec Ghost and copy the entire image from the old drive to the new one.

Then you can boot from the new drive and all your programs and data will still be working.

by nigel100

1:some hds come with a util that will copy everything from one hd to the other (you could check manufacturers website)
2: have your existing hd set to master and the new one set to slave. boot as win normal. copy the entire c: to the 1st partion ofthe new drive. reboot from floppy and use fdisk to make the new drive active. remove the floppy and reboot.

This discussion is closed to new replies.