Question Locked

New Laptop Hard Drive and DVD drive

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Both my hard drive and dvd drive have recently stopped working so I purchased replacements. I assumed they would plug and play where I could install windows XP from the new DVD drive, but they computer doesnt recognize either.

"Primay hard disk drive not found
Fixed optical drive not found"

I have an A: promt from creating a startup disk, but I cannot do much else. If I try to change drives, I get
"Invalid drive specification."

Any and all help would be appricated. How can I get it to see the new drives?

Thanks,
Jonathan C. Bagwell

7 replies

by hal 9000

You should see a prompt to press a key to enter the BIOS or maybe it's called Startup. You need to press this key which could be just about any Function Key or the Delete Key depending on the model of your NB but it will be there.

Once you get into the BIOS you'll need to look at changing the HDD you may need to enter in the Cylinder Head Sector & Size instead of allowing the NB to Auto Detect the Drive and it will have to be smaller than th Max Size that your NB's BIOS will actually read. You may also need to open the various BIOS Screens just to allow the BIOS to see the new Optical drive and set it in the BIOS and then save the changes and exit.

If the HDD is within the capacity of the BIOS to read you should be able to reload the computer from that stage just by dropping in the Recovery or OEM Windows Install CD.

Col

by mr_jonbag

Col,

Thank you for you help and quick response, but I have found nothing in my BIOS that I can change to do with the hard drive except for the boot order. The page that shows my drives and installed devices only allows me to change the date and time.

Something else I have tried with no luck:

I have also tried pressing F12 which brings me to a boot screen. I am selected the diagnostics option and it goes through a pre-boot system assessment Build 3008.

It completes three tests, CPU time stamp calibration, PIC Functionality test, and A20 Gate test. All of which pass. The fourth, the "start DST short test" fails with error code 1000-0141 with message "no drive detected"

When I continue with the Pre boot system assessment, the rest of the tests pass and it ends with the message:

"No diagnostic utility partition found. To run diagnostics insert your dell drivers and utilities CD then select ok to restart they system and boot off the CD.

Since my DVD drive is not recognized, this does not work.

Hopefully this is just me being stupid and there is a simple way to get my BIOS to notice my drives.

Please set me strait.

Thanks,

Jonathan C. Bagwell

This discussion is closed to new replies.