Question Locked
0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
i installed new motherboard and processor and when booting up it will not find my sata hard drive. i enabled all sata controls in the bios, but still wont recognize. what can i do further to access this hard drive.
2 replies
by randallr Accepted solution
Clarifications
by hal 9000 Accepted solution
Go into Computer Management and load the drivers for your SATA Controller beside the yellow circle with the exclamation mark through it. These drivers came on the Floppy & CD that came with the M'Board.
If you are trying to boot off this SATA Drive you'll need to do a repair install of Windows XP by following the directions here
http://tinyurl.com/g4bv8
and press the F6 key when prompted to install any additional drivers so that you can install the necessary SATA Drivers for the System to work.
Col
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies